Category: Connector Cables
Showing 1–12 of 42 resultsSorted by latest
-
×
2pc Flywoo JST-SH 1.0mm 8-Pin FC to ESC Connection Cable
£1.95 (ex VAT: £1.63)
Short and sweet! Flywoo’s 8-Pin FC to ESC cable is your go-to for hassle-free connections. Pre-marked, prepped, and ready to simplify your stack build.
Only 2 left in stock
Open full product page30Only 2 left in stock£1.95 (ex VAT: £1.63) -
×
Sparkfun FTDI to USB-C Cable – 5V VCC-3.3V I/O
£14.95 (ex VAT: £12.46)
Tired of playing USB-port roulette? The FTDI to USB-C cable brings you fast, foolproof serial connections, no matter which way you plug it in. Just remember: RTS, not DTR!
Only 2 left in stock
Open full product page01Only 2 left in stock£14.95 (ex VAT: £12.46) -
×
RF Cable N Female to RP-SMA Male-CFD400-Black-1m
£15.36 (ex VAT: £12.80)
Because nothing says ‘I love you’ to your SenseCAP Gateway quite like the CFD400 RF Cable – it’s the ultimate electronic wingman, ensuring your signals mingle and connect like socially adept electrons at a physics conference!
In stock
Open full product page00£15.36 (ex VAT: £12.80) -
×
Replacement Screw Set for ZMO PRO
£12.95 (ex VAT: £10.79)
Ever tried flying your drone without screws? It’s like juggling water! Don’t be that person. Get our ZMO PRO Screw Set
Only 1 left in stock
Open full product page00Only 1 left in stock£12.95 (ex VAT: £10.79) -
×
ZMO PRO Replacement Wing Cable Set
£7.75 (ex VAT: £6.46)
This is a replacement cable set for your ZMO PRO Wing assembly. It connects your Motor and wing servos to the 7pin fuselage connector.
Out of stock
Open full product page
Restock in 2+ Weeks00Out of stock
Restock in 2+ Weeks£7.75 (ex VAT: £6.46) -
×
ZMO PRO Replacement Fuselage Cable Set
£7.75 (ex VAT: £6.46)
This is a replacement cable set for your ZMO PRO Fuselage assembly. It connects your ESC and Flight controller to the 7pin wing connector.
Only 2 left in stock
Open full product page00Only 2 left in stock£7.75 (ex VAT: £6.46) -
×
2m cable for Reach RS w/o 2nd connector
£24.32 (ex VAT: £20.27)
This is a 2m cable that has a reach connector on one end, allowing you to hook up your own custom connector for your own power needs.
Only 2 left in stock
Open full product page00Only 2 left in stock£24.32 (ex VAT: £20.27) -
×
Pre-Crimped DIY Cable Kit – JST MX1.25 Connectors
£12.95 (ex VAT: £10.79)
A kit that includes everything you need to wire up just 1.25mm pitch connectors commonly found on FPV cameras and some autopilots such as Pixhawk.
In stock
Open full product page01£12.95 (ex VAT: £10.79) -
×
Pre-Crimped DIY Cable Kit – SH1.0 Connectors
£14.95 (ex VAT: £12.46)
A kit that includes everything you need to wire up just about all the known FPV flight controllers.
In stock
Open full product page00£14.95 (ex VAT: £12.46) -
×
Interface Cable – SMA Male to TNC Male (2m, 5m)
£7.95 – £9.95
Open full product pageThis is a Male TNC to Male SMA cable (available in multiple lengths).
00£7.95 – £9.95 -
×
Cable Set For Pix32 V5
£10.45 (ex VAT: £8.71)
This is a replacement cable set for the Pixhawk Pix32 V5 autipilot system. It includes all the basic wires and cables you need to hook up your autopilot system.Out of stock
Open full product page
Item discontinued00Out of stock
Item discontinued£10.45 (ex VAT: £8.71) -
×
OpenMV Camera Module Extension Cable
£8.75 (ex VAT: £7.29)
The Camera Module Extension Cable allows you to separate the camera module from the motherboard. The extension cable is useful for any application where you need to place the camera module and processor body in different locations. The cable is approximately 7cm long.
Out of stock
Open full product page
Restock in 2+ Weeks00Out of stock
Restock in 2+ Weeks£8.75 (ex VAT: £7.29)
